11/13/2023 0 Comments 2010 camaro sequential tail lights![]() ![]() ![]() ![]() V8 GAS OHV Naturally AspiratedĦ.2L 6162CC 376Cu. V6 GAS DOHC Naturally AspiratedĦ.2L 6162CC 376Cu. The top two bolts holds the lamp just fine.This part is compatible with 28 vehicle(s) Notesģ.6L 3564CC 217Cu. I dropped mine on both sides before I came up with the fishing line idea. Works like a charmįWIW you can forgo trying to put the outer lower bolt back on (as it's virtually impossble to do anyway without removing the bumper). This way if you drop a bolt when putting it back on (and you most likely will.LOL) you wont lose it. Tie the other end to the knob the light cover goes over. When removing the lights, after unscrewing the outer upper and bottom bolts tie a piece of thin fishing line to them, it won't affect being able to bolt them back on. Make sure to clean off any existing adhesive on the housing and cavity first or the emblem tape won't hold. Use 3M emblem tape to reattach the housing. When removing the Techno lights start by detaching the resistor housing from the light cavity to give yourself more room to work with. Love these tail lights, just wish there wasn't so many issues with them!įrom your lips to God's ears! Post back with your results. I will hopefully have some time this weekend to give it a try. TIP -to remove condensation dry the inner lense with a hair dryer and clean it with a piece of guaze lightly dipped in distilled white vinegar, then redry it with the hiar dryer. I applied some GE Silicone II Clear Window and Door Caulk all around the seal. Ps- I took mine off the dy after it rained and saw water droplets on the rubber seal on on the top of the housing. I didn't know they were different Do you recall what the difference is and what screws go where ? I really struggled to get the 4 long screws reconnected. Hey Guy, Many thanks for making this video Wish it was last week when I had my driver outer apart to dry out condensation on the inner lense. The best part is that there is no baking and re-gluing needed at all. The exact replacements I purchased are listed below too. It turned out to be quite easy! No audio, just narrations, but the video should guide you. I purchased some replacement strips for under $10. Although the manufacturer offered to replace the led strips, it was still quite expensive so I thought I would give it a try on one light and see how it went. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |